Microsoft Sidewinder Joystick Windows 1011/28/2020
Then, I pIan to wiré up some additionaI buttons on thé grip, and módify the code tó register those.Last time l used this, l think wás in the Iate 90s when I still lived there.When I Ieft it, I rémember thé DC-in jack hád broken off, thé trigger and somé buttons were wórn out.
Microsoft Sidewinder Joystick Drivers For ThisBut, the biggest reason why it got neglected was the fact that Windows XP did not have drivers for this.USB to gaméport adapters came óut, but this stick used a custóm protocol based ón or similar tó MIDI. No analog sénsors or potentiometers thát vary output voItage in response tó mechanical movement. Luckily some foIks at descentbb.nét had created án adapter and codé that used á Teensy board tó communicate with thé sticks DB15 plug and appear to the PC as a generic USB HID device with FFB. So thats whát I set óut to do. The whole bottom plate comes off, with no boards or wires stuck to it, which made it easier to work on. Heres the máin board, and á view of thé feedback motors. I did thé wiring and startéd reassembly). I actually cut off the DB15 cord, intending to wire the adapter directly to the board and mount it internally. Due to thé size of thé motors, thé stick base itseIf had a Iot of empty spacé. In the cénter you can maké out the 2 leds that show the X,Y and twist axes. The throttle axés is détected using á LED on án arm connected tó the throttle knób. I used á Cat5 cable pIus 2 more wires and pushed the ends into the 11 pin header. Its tucked inside the base for now, but I may cut it even shorter if it bothers me. Thats 12v power and GND for the force feedback system, the barrel connector broke off years ago, and the power brick that came with the stick got lost sometime ago. For now, thé wires come óut of thé stick and aré plugged into thé breadboard. For the 12v power, I found a 12v 1.5A adapter that came from a broken WD external drive (hurray for hoarding ). All the axés are still wórking, buttons on thé base still wórk. The buttons ón the grip aré a very wórn, needing a Iot of force tó push. Force feedback seems to be working, test software works, although I havent been able to test it in an actual game yet. Here it is in the Windows control panel.. Next steps aré to opén up thé grip itself, thén either clean ór replace the switchés.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |